General Finishes High Performance Polyurethane Top Coat (Gallon)

Description

Winner of Fine Woodworking's Best Overall Choice Award, High Performance Topcoat was voted as the hardest, most durable consumer polyurethane topcoat on the market today. It contains a UV Stabilizer to retard the finish from breaking down in sunlight. And with its pure polyurethane durability, This is the most durable product.
Colors
:
Water White (dries clear). Note: Water topcoats can pull tannins, stains and dyes from surfaces that are not properly prepped. Stain blocking primer may be required under white or light colored paints to prevent bleed-through.
Type
: Water-Based
Sheen
: Gloss, Semi-Gloss, Satin, or Flat
Interior/Exterior
: Interior Only
Product Type
: Urethane/Acrylic Blend
Coats
: 3 Coats
Coverage
: 600 Sq. Ft./Gallon
Viscosity
: 50-60 sec.
Application Method
: Brush, Roll or Spray
Spray Tip Size
: HVLP .043 - .051 Medium Air Cap
Durability
: High
Dry Time to Touch
: 30 Minutes
Dry Time to Re-coat
: 2 Hours
Water Spills and Daily Use
:
Clean water spills up as they occur during regular use and protect from heat.
Although General Finishes products are water resistant, they are not impervious to water. Surfaces will not be damaged by spilled water so long as it is cleaned up promptly. We recommend using coasters to protect your wood from standing water and pot holders to protect from heat.
Cleaning Your Finish
: Clean with a water-damp rag. Do not clean until the finish has cured completely (21 days).
If your surface requires deep cleaning due to grease or grime, add a speck of detergent or a bit of vinegar.
Avoid using oil-soap or silcone-based daily cleaners such as Pledge, Endust or Murphy's Oil.
WARNING
: TEST FOR COMPATIBILITY WHEN USING THIS PRODUCT WITH PRODUCTS FROM OTHER BRANDS.
General Finishes products should be tested to your complete satisfaction before using. General Finishes will not be responsible for any failure if our products are used in conjunction with other brands of finishes. We do not test General Finishes products with those of another manufacturer and will not accept liability if there is a compatibility issue.